- The innovative Flexicure gooseneck lights design increases the energy value by 30,000uW/cm²* in the 1~3cm irradiation range, which greatly enhances the curing effect on details such as the top of the model and the figure's skirt.
- Compared to the previous generation Anycubic Wash & Cure Plus, brand-new arrangement of lamb beads combined with a lens light source offers a 20% improvement in curing uniformity*. This results in a more thorough and comprehensive overall curing of the model, ensuring better quality and consistency.
- Two cleaning modes, basket cleaning and hanging cleaning, can meet more practical model cleaning needs
- The cleaning basket has been updated to PP material to avoid rusting and extend its life span
- Dual cleaning and curing modes,and gooseneck light curing mode, are easily selected at the click of a button and can be adjusted from 1 to 30 minutes
- Through structural design and software optimization, it reduces the noise interference generated during woking, providing a quiet environment
- 【Size Upgraded, Capacity Increased】Compared with Anycubic wash & cure plus, wash and cure 3 plus’s washing basket volume is increased by about 13.4% to 7.6L, and total volume of the washing bucket is 12L, which is suitable for LCD 3D printers of 10.6'' and below.
- 【Partial Enhanced Curing】The innovative Flexicure gooseneck lights increases the energy value by 30,000uW/cm²over a 1-3 cm irradiation range, thus taking good care of delicate areas such as the top of the model or figure details.